High temperature solder kit for on-site cable assembly fabrication

Wilcoxon's 6Q-style connector fills the need for a higher temperature, more reliable, underwater exposure connector for 2 and 3-pin MIL-style sensor connections. The HTS (high temperature solder) kit is used when sockets must be soldered to the wires.

Each tool kit contains three 2 oz tubes of epoxy, which is enough to assemble a maximum of approximately 75 connectors (connectors and cabling must be ordered separately). One 2-oz tube of epoxy will pot approximately 25 connectors. Keep in mind that the mixer nozzles are disposed of after one use. If 5 connectors are epoxied at the same time, you would need 5 mixer nozzles per tube of epoxy. If you epoxy 25 connectors at the same time, you would need 1 mixer nozzle per tube of epoxy.

Included parts

• High temperature epoxy - used to ‘dab’ onto spring
• Metal socket insertion tool - installs connector sockets into connector body
• Plastic socket insertion tool
• Crimp tool - crimps backshell to crimp sleeve to hold shield
• Wire stripper - strips the wire conductor insulation to length
• Scissors - use to trim shield braid and fiber strands
• Exacto knife -15 blades, use to score and cut cable jacket
• Plastic knife guard - guards for the Exacto blades
• Epoxy nozzle, EPX - mixing nozzle, mounts on the plunger
• Epoxy plunger 4:1 - holds the two-part epoxy
• Epoxy applicator gun - holds epoxy, pushes plunger to dispense epoxy into backshell
• Carrying case with foam - holds all the components of the kit